Wrought iron
Wood & steel frame
Farm & ranch
Sliding driveway gates
LiftMaster operatorsFree on-site gate assessment - hinges, posts, and your LiftMaster or Nice gate operator checked before anything is quoted
The assessment is free and the quote is the invoice.
Get your free estimateStyles & brands we work with
- Wrought iron
- Wood & steel frame
- Farm & ranch
- Sliding driveway gates
- LiftMaster operators
See the difference
Before
After
Before
After
Before
AfterAutomatic Gate Repair in Summerlin, NV
Automatic gate repair in Summerlin covers the motor, control board, safety sensors, and mechanical drive that let a driveway gate open without anyone getting out of the car. When a gate stops responding, the problem is usually one of a handful of failure points we can identify in the first hour. Vance Gate Repair Summerlin works on the nine major automation brands already on Summerlin properties, so we can repair the motor you have instead of pushing a replacement. Call (844) 797-2809 and a live person picks up, any hour.
This page sits under our broader Gate Repair service, which covers hinges, welds, posts, and structural work. Automatic gate repair is the electronics and drive side: the arm, the operator, the receivers, and the wiring that ties it all together. Our technicians have up to 12 years of experience, and every visit ends with a photo log of what we found, what we adjusted, and what we replaced.
When You Need Automatic Gate Repair
Automatic gates usually fail in predictable ways. Most Summerlin calls we take fall into one of these categories:
- The gate opens but won’t close. Usually a misaligned photo-eye (the infrared beam that stops the gate if something crosses the path) or a limit switch that has drifted past its set point. Common after a heavy monsoon-season wind event knocks a sensor bracket loose.
- The motor runs but the gate doesn’t move. Often a stripped drive gear or a failed torque limiter. On Mighty Mule operators, this shows up most often as a loud grinding sound before the arm gives out.
- The gate moves a few inches and reverses. A safety sensor or a torque setting telling the controller the gate hit an obstruction. Sometimes the fix is a 10-minute sensor realignment; sometimes it’s a control board.
- Clicking, no movement, no sound. Dead control board, blown fuse, or a low battery on a solar-powered operator. Solar gates are common in the hillside pockets of Summerlin, and a battery that won’t hold a charge after three summers is a routine replacement.
- The remote works only up close or not at all. Antenna damage, receiver failure, or a remote that needs re-pairing. We test both the remote and the receiver before recommending anything.
- The gate is stuck open after a power outage. The manual release wasn’t re-engaged, or the control board lost its memory and needs recalibration. LiftMaster and FAAC boards both need a re-learn after certain outages.
If your gate has a structural problem instead (a sagging hinge, a cracked weld, a bent track), that work falls under our home service overview and gets handled on the same visit when possible.
Our Automatic Gate Repair Process

Every job walks through the same steps, whether it’s a five-minute limit-switch reset or a full operator replacement. The process is governed by The Haven Standard, our written commitment to pricing, documentation, and standing behind every repair.
- Written price before work begins. The first thing we hand you is a flat written scope and price. No verbal estimates, no “call for a quote.” Under Haven Standard Clause 1, you have it in writing before we pick up a tool.
- Diagnostic and symptom confirmation. We ask what the gate has been doing, then verify it ourselves. A gate that reverses at 20 inches on a Tuesday may behave differently by Thursday, so we test under real load, not just in the shop.
- Wiring and limit-switch reading. We meter the control board, photograph the wiring as-found, and record limit-switch positions before we adjust anything. This is the commercial access-control habit our founder brought over from job sites in 2014.
- Repair, adjust, or replace (whichever the evidence supports). We service LiftMaster, FAAC, BFT, Linear, Viking, Ghost Controls, DoorKing, Elite, and Mighty Mule operators. If a $40 gear will fix a $900 motor, we replace the gear.
- Full cycle test under load. We run the gate open and closed three to five times, check the safety reverse, and verify the photo-eye triggers on obstruction. If it doesn’t pass, it doesn’t ship.
- Photo record and written close-out. Before we leave, you get a photo log of every adjustment and a written record of the part number installed. That record is filed under Haven Standard Clause 4, Evidence on Every Job.
Before
AfterAutomatic Gate Repair Pricing in Summerlin
Most automatic gate repairs in Summerlin run between $185 and $650, depending on the operator and what failed. The range is wide because the failure could be a $12 fuse or a $450 control board. We give you the exact number in writing before starting, so you aren’t guessing.
| Repair | Typical Price Range | What It Covers |
|---|---|---|
| Limit-switch adjustment | $185 – $240 | Reset, calibration, photo log |
| Photo-eye / safety sensor replacement | $220 – $320 | New sensor pair, alignment, wiring check |
| Remote / receiver re-pair or replacement | $195 – $340 | Diagnostic, new receiver or remote, pairing |
| Control board replacement | $340 – $620 | Board, wiring diagram, full re-learn |
| Swing-gate arm motor replacement (Mighty Mule, LiftMaster) | $550 – $1,100 | Motor, mounting bracket, calibration |
| Sliding-gate operator drive gear / torque limiter | $280 – $520 | Gear or limiter, torque reset, load test |
| Solar battery replacement | $230 – $380 | Battery, charge-rate check, control board memory test |
What moves the number: the brand and age of the operator, whether wiring needs to be run, and whether the gate is a swing or slide. FAAC and BFT hydraulic arms, for instance, tend to cost more to service than a Mighty Mule because the seals and fluid are part of the job. If a company has already given you a written quote and you’d like a second look, we’ll review that paperwork at no cost under our free second-opinion offer.
FAQs – Automatic Gate Repair

Can you repair an automatic gate the same day in Summerlin?
Yes, most automatic gate calls in Summerlin can be handled the same day, and a live person answers our phone 24 hours a day. Board-level failures and motor replacements sometimes need a part ordered, but the diagnostic and written price happen on the first visit regardless. Call (844) 797-2809 to schedule.
How much does automatic gate repair cost in Summerlin?
Most automatic gate repairs in Summerlin cost between $185 and $650, with control board and motor replacements running higher. The exact number depends on the brand, the part, and whether wiring needs attention. You get the flat written price before any work begins, so the number you agree to is the number you pay. Call (844) 797-2809 for an exact quote, free of charge.
Is it cheaper to repair or replace an automatic gate operator?
Repair is almost always cheaper than replacement when the operator itself is sound and only a component failed. We service nine brands, including LiftMaster, FAAC, BFT, and Mighty Mule, so we aren’t steering you toward a new motor to avoid a brand we don’t carry. If the operator is truly at end of life, we tell you in writing and show you the readings. Call (844) 797-2809 to talk through your specific gate.
What does the 365-Day Done Right Promise cover?
The 365-Day Done Right Promise means if our repair doesn’t hold, we make it right at no additional charge for a full year, with no argument and no fee. It applies to every completed automatic gate repair we do. If the gate misbehaves inside that window, call (844) 797-2809 and we schedule the return visit.
For automatic gate repair in Summerlin, the call you make gets you a written price, a live person on the other end of the line, and a photo record you can hand to any future technician. Call (844) 797-2809 for a free estimate. A background-checked technician arrives with a name, a photo, and a written scope before any work starts, and our 365-Day Done Right Promise covers every repair we complete.
Written by the team at Vance Gate Repair Summerlin, serving Summerlin.