Wrought iron
Wood & steel frame
Farm & ranch
Sliding driveway gates
LiftMaster operatorsFree on-site gate assessment - hinges, posts, and your LiftMaster or Nice gate operator checked before anything is quoted
The assessment is free and the quote is the invoice.
Get your free estimateWhy Summerlin Homeowners Choose Mighty Mule Gate Repair
We provide independent Mighty Mule gate repair in Summerlin, NV, and our Mighty Mule work is different because we troubleshoot the operator itself: control board, actuator arm, limits, battery and solar stack. A Mighty Mule that reverses halfway or stalls on one arm usually has a diagnosable cause, not a mystery. Most Summerlin Mighty Mule repairs run between $185 and $420, and that price is written and handed over before anyone touches the motor. Call (844) 797-2809.
To be clear: we’re an independent Mighty Mule service provider. We’re not affiliated with, authorized by, or endorsed by the manufacturer. Nor do we insist a Mighty Mule be swapped for another brand. We repair what’s on the property.
Summerlin’ Mighty Mule population is real. These are the units homeowners install on DIY weekends, then live with through 110-degree summers.
Why Trust Vance Gate Repair Summerlin for Your Mighty Mule Gate Repair?
Our technicians have up to 12 years of experience, and a good chunk of that has been spent inside Mighty Mule operators. These are not complicated machines. That’s exactly why half-tuned installs stick around so long: the gate opens, so nobody looks closer at the lagging arm or the limit switch set a few degrees off travel.
We source OEM-compatible parts for FM-series and MM-series units and can tell you when an aftermarket arm or battery meets or beats the original for less money. Warranty-safe service means we don’t cut harnesses, we don’t bypass the board’s diagnostics, and we document the part numbers so a future warranty claim has a paper trail.
Every visit is covered by the 365-Day Done Right Promise: if a Mighty Mule repair isn’t right, we make it right at no charge within that window. Before we leave, you get a photo record of what we found, what we set, and what we installed. Bring a written estimate from another company and we’ll review it free of charge.
Styles & brands we work with
- Wrought iron
- Wood & steel frame
- Farm & ranch
- Sliding driveway gates
- LiftMaster operators
Common Mighty Mule Gate Repair Problems We Fix in Summerlin

- Control board and limit-switch failures. The arm stalls, reverses mid-travel, or runs past its open and close positions. On FM500 and MM360 units this often traces to a limit switch that has drifted out of adjustment, not a dead board. We read the limits, reset them, and photograph the new positions before we call it fixed.
- Worn actuator arm bushings and clevis pins. On dual-swing Mighty Mule setups (FM600, MM560), the bushings and clevis pins wear until one arm sags and binds. Uneven closing is usually geometry, not electronics. A worn clevis on the lagging arm is a $40 part that gets diagnosed as a $900 operator far too often.
- Battery and solar-charging faults. This is the Summerlin classic. Mighty Mule operators rely on a backup battery and often an undersized solar panel. In 100-plus-degree heat, batteries age faster and a small panel can’t keep up. The gate works all morning and dies by evening.
- Keypad and receiver pairing dropouts. A wireless keypad stops accepting codes, or the remote loses range after the board or antenna was disturbed. We re-pair the accessory stack and check antenna placement, since an entry keypad on a HOA-governed community gate has to work every time.
- Out-of-plumb posts and misalignment caused by caliche and clay soils. Summerlin lots sit on fill and caliche-laden expansive clay. A gate that “just needs adjusting” often has a heaving or settling footing underneath. We check the posts for plumb before we ever re-hang the gate.
Before
AfterMighty Mule Parts & Our Repair-vs-Replace Approach
We lean on genuine Mighty Mule boards, arms and hardware where the model calls for it, and quality aftermarket arms, batteries and receivers when they match or beat OEM durability for less. For an MM260 swing operator, that’s usually a board or a battery. For an FM350 on its second decade, the honest call may be replacement.
We don’t stock parts and we won’t pretend to. We diagnose first, then source the right part for the job. That keeps us honest about what’s actually needed.
Boards, arms and batteries on older FM/MM units are usually worth fixing. A rusted-through frame or an obsolete board that’s no longer made can tip the balance toward replacement. When replacement is the smarter move, we tell you plainly and price it. When a repair will do the job for years, we say that too. Either way, the price is in writing first.
Call (844) 797-2809 for a free estimate on your Mighty Mule.
Our Mighty Mule Service Process – Step by Step

- 1
Diagnosis. We check arm geometry and hinge posts for binding, read the limit-switch positions, and test the control board and battery under load to isolate whether the fault is mechanical or electrical. Every reading is recorded.
- 2
Written price. Before a tool comes out, you get the scope and the price in writing. The number you agree to is the number on the invoice.
- 3
Repair or install. We replace the board, arm, battery or accessory with the right part for the model, and we re-pair keypads and receivers after any board work.
- 4
Test and document. We cycle the gate through full open and close, verify the safety reverse and limits, and hand you a photo log of the settings and the part numbers installed. The 365-Day Done Right Promise backs the work.
See the difference
Before
After
Before
After
Before
AfterMighty Mule Products We Service & Install in Summerlin
We service Mighty Mule FM-series single and dual swing openers (FM350, FM500, FM600) and the MM-series swing operators (MM260, MM360, MM560). We also repair Mighty Mule slide gate operators, including the MM371 and MM571 slide models. The accessory stack comes with the territory: wireless keypads, exit wands, solar panels and battery backups. When a motor, realignment or battery backup job needs replacing rather than fixing, we’ll give you the written price on both paths so you can choose. HOA architectural approval on a community gate in Summerlin is part of that conversation.
We Also Service These Brands

Mighty Mule is one brand. If your community entry runs a DoorKing or your neighbor’s gate uses LiftMaster, or you have Ghost Controls on a newer DIY install, we work on all of them. Being multi-brand means we diagnose the motor that’s actually on the property instead of steering you toward a replacement. One company, nine brands serviced.
FAQs – Mighty Mule Gate Repair Service in Summerlin
Is Vance Gate Repair Summerlin authorized by Mighty Mule? No. We’re an independent Mighty Mule service provider and not affiliated with or authorized by the manufacturer. We’re trained on the brand and repair it daily, and our work and parts sourcing are our own.
Do you use genuine Mighty Mule or OEM parts? Yes when the model calls for it. We source genuine Mighty Mule boards, arms and hardware where appropriate, and quality aftermarket parts when they match or beat OEM durability for less. Whichever part goes in, you get the part number in writing and a photo of the install.
How long does Mighty Mule service take? A limit reset or realignment is typically a same-day repair of one to two hours. A board or actuator arm replacement runs longer because we test and re-pair accessories afterward. We give you a written time estimate during diagnosis, not a guess over the phone.
What Mighty Mule models and series do you cover? FM350, FM500, FM600, MM260, MM360 and MM560 swing operators, plus MM371 and MM571 slide models, along with the keypads, exit wands, solar panels and battery backups that go with them. If you’re not sure which series you have, read the label inside the control box and tell us.
Will service void my Mighty Mule warranty? Not when it’s done properly. We don’t cut harnesses or bypass board diagnostics, and we document the part numbers so a warranty claim has a paper trail. That record is often what keeps a claim clean instead of contested.
How much does Mighty Mule gate repair cost in Summerlin? Most Mighty Mule repairs run between $185 and $420, with limit resets and realignments at the low end and board or arm replacements higher. You agree to the written price before any work starts. Call (844) 797-2809 for an exact quote. Estimates are free.
Book Your Mighty Mule Service in Summerlin, NV

A Mighty Mule that reverses halfway or dies by evening is fixable, and the fix is usually cheaper than replacing the operator. Call (844) 797-2809 for a free estimate on your Summerlin gate. We’ll diagnose the operator, give you the price in writing before work starts, and leave you a photo record of every adjustment. A live person answers the phone at any hour.
Written by the team at Vance Gate Repair Summerlin.