Wrought iron
Wood & steel frame
Farm & ranch
Sliding driveway gates
LiftMaster operatorsFree on-site gate assessment - hinges, posts, and your LiftMaster or Nice gate operator checked before anything is quoted
The assessment is free and the quote is the invoice.
Get your free estimateMighty Mule Gate Motor & Opener in Summerlin: What to Know First
As an independent Mighty Mule service provider, we diagnose, repair, and replace Mighty Mule gate motors and openers across Summerlin, and most swing-gate motor repairs are completed in a single visit once the correct part is on hand. Straight repairs usually run $210 to $390, and a full motor replacement typically lands between $780 and $1,450 depending on the unit and whether the arm bracket is still intact. You get a flat written price before any tool comes out, so the number on the page is the number on the invoice.
This page is for Summerlin owners of Mighty Mule single and dual swing openers already on the post, whether it’s a back-gate unit tucked behind a Red Rock-adjacent cul-de-sac or a double-leaf entry in The Ridges. Call (844) 797-2809 and a live person answers, day or night.
How Mighty Mule Products Fail – and How We Fix Them
- MM560W and MM562 control-board corrosion. The single and dual swing units in this line pack the board into a housing that collects fine desert dust, and once it settles across the terminals a light rain turns it into a conductive paste. The symptom owners describe is a gate that runs a few inches, stops, and reverses with no obstruction in the path. We pull the board, clean the block, and reseal the enclosure; if the traces are eaten through, we replace the board with an OEM unit rather than an aftermarket clone, because the clones drop the surge protection the originals carry.
- Solar-charged Mighty Mule units losing their mind in June and July. A lot of Summerlin gates sit on Mighty Mule solar kits, and by midsummer the panel is baking at 150°F-plus on a west-facing post while the battery is older and holding less. The gate gets sluggish, then starts stalling halfway through travel, and the owner assumes the motor is dead. Often it’s the battery or a shaded panel, not the arm. We test the battery under load, check panel angle, and tell you which one to replace instead of swapping the whole opener.
- MM260 and MM360 limit-switch drift. These slide and swing arms use mechanical limit switches, and the screw that holds the cam walks under vibration. We’ve reset units set 12 degrees past travel – the gate buries itself into the stop, the controller reads a fault, and it times out. That’s a $40 part and an hour of labor, not a motor replacement. We photograph the new limit position so the next technician reads the same number.
- Operator arm and bracket fatigue. The push-arm geometry on Mighty Mule openers puts load on the gate-post bracket every cycle, and on a heavy ornamental leaf the original lag bolts work loose over a few summers. When the bracket pulls, the arm binds and the controller faults out. We replace the bracket assembly, re-anchor it correctly for the post material, and check the operator arm for the bend that usually follows.
- Battery backup failing quietly. Mighty Mule’s backup batteries are a wear item, and in Summerlin heat they expire faster than the manual suggests. The gate works fine on AC right up until the breaker trips or the power blips, then it won’t open at all. We load-test the backup and replace it before it strands you, then log the install date on the sticker inside the housing.
Styles & brands we work with
- Wrought iron
- Wood & steel frame
- Farm & ranch
- Sliding driveway gates
- LiftMaster operators
Our Mighty Mule Gate Motor & Opener Process

- 1
Call and describe what the gate is doing. A live person takes it 24/7. We ask for the model number off the housing and what the gate did last – stalled, reversed, went dead, or ran on AC only.
- 2
Diagnose on site. We meter the battery, read the limit switches, inspect the control board, and check the arm and bracket for binding. No guessing, no parts thrown at it.
- 3
Parts decision, in writing. You get a written price for the OEM part and, where a quality aftermarket option makes sense, that price too – with our recommendation and why. You choose. Nothing gets ordered until you’ve seen the number.
- 4
Make the repair. Board, limit switch, battery, arm, or full motor – swapped and set to spec, with wiring documented as we go.
- 5
Test the full cycle. We cycle the gate open and closed, test the photo-eye and any safety edge, verify the obstruction reverse, and confirm the battery backup takes over when we pull AC.
- 6
Leave the record. Before we go, you get a photo log of every adjustment and a written record of the part number installed, filed in the job record. Under the 365-Day Done Right Promise, if the repair isn’t right within a year, we make it right at no additional charge.
Before
AfterWhat Mighty Mule Gate Motor & Opener Costs in Summerlin
Here’s what Mighty Mule work actually runs in Summerlin. These are flat written prices, handed to you before work starts – not “call for a quote.”
| Job | Typical price |
|---|---|
| Control-board replacement (MM560W/MM562) | $260 – $410 |
| Limit-switch reset or replacement | $120 – $210 |
| Battery / solar backup replacement | $140 – $240 |
| Operator arm or bracket repair | $210 – $360 |
| Full swing motor replacement (single) | $780 – $1,450 |
| Dual-gate second motor added | $650 – $1,100 |
What moves the price: single vs dual leaf, OEM vs aftermarket part, whether the bracket and arm are reusable, and whether we need to correct the wiring at the same time. Estimates are free, and the price is agreed before any work begins. Call (844) 797-2809 for an exact quote.
See the difference
Before
After
Before
After
Before
AfterWhy Summerlin Homeowners Call Vance Gate Repair Summerlin for Mighty Mule Work

We’re not affiliated with or authorized by Mighty Mule, and we don’t steer you toward a replacement when a repair will do. What we bring is the documentation habit: our technicians have up to 12 years of experience, and every visit leaves a photographed, written record of what we found and what we set. Nine major brands serviced – Mighty Mule, plus LiftMaster, Ghost Controls, DoorKing and the rest – so we can work on whatever motor is already on your property instead of selling you a new one.
The 365-Day Done Right Promise covers the repair for a full year. If you’ve got a written estimate from another Summerlin gate company, bring it in and we’ll review it free – a second opinion costs nothing and often catches a motor replacement that wasn’t necessary. A live person answers the phone any hour.
FAQs
No, repair work by an independent service provider doesn’t void the Mighty Mule warranty, and we use OEM parts where they matter to protect it. We’re upfront about which parts are OEM and which are quality aftermarket, so you’re never guessing. Call (844) 797-2809 and we’ll walk you through it.
Most common Mighty Mule parts – control boards, limit switches, batteries, arms – are available quickly, and many repairs are done with parts on hand the first visit. Less common parts get ordered and scheduled, usually within a few days. Call (844) 797-2809 for availability on your model.
Repair almost always wins when the motor and gearbox are sound and the fault is a board, switch, battery, or arm – that’s typically a fraction of replacement cost. Replacement makes sense when the housing is cracked, the motor is failing, or the parts are no longer made. We tell you which it is, in writing, before anything is ordered. Call (844) 797-2809 for an honest read.
For a gate stuck open or dead, we aim to get a technician out same-day or next-day, and a live person takes your call 24 hours. Full motor replacements and parts orders are measured and scheduled to fit the job. Call (844) 797-2809 to book.
Yes – on any Mighty Mule install or repair we test the battery backup under load, verify the photo-eye and safety edge, and confirm the obstruction reverse works before we leave. That’s part of every job and documented in the photo record. Call (844) 797-2809 for a free estimate.
Get Your Mighty Mule Gate Working Again

Call (844) 797-2809 for a free estimate on Mighty Mule gate motor and opener work in Summerlin. A live person answers any hour, we hand you a flat written price before any work starts, and we leave a documented photo record when we go. Gate stuck open, stalling, reversing, or dead on battery backup – we’ve seen it, and we’ll tell you exactly what it costs.
Written by the team at Vance Gate Repair Summerlin, serving Summerlin and nearby areas.