Wrought iron
Wood & steel frame
Farm & ranch
Sliding driveway gates
LiftMaster operatorsFree on-site gate assessment - hinges, posts, and your LiftMaster or Nice gate operator checked before anything is quoted
The assessment is free and the quote is the invoice.
Get your free estimateGhost Controls Gate Motor & Opener in Summerlin: What to Know First
We service Ghost Controls gate motors and openers in Summerlin as an independent service provider. Most repairs are completed in a single visit and range from about $150 for a sensor or limit adjustment to $650+ for a full arm replacement, depending on the model and whether the control board is involved. You get the flat price in writing before any tool comes out, and a photo record of what we found and what we changed when we leave.
This page is for Summerlin homeowners who already own a Ghost Controls system and want it working again, not replaced on a sales pitch. If your gate stopped mid-travel, the remote quit, or the arm short-cycles at the end of its run, call (844) 797-2809. A live person answers, day or night.
How Ghost Controls Products Fail – and How We Fix Them
Ghost Controls systems are common on Summerlin driveways because they’re a good fit for single-leaf swing gates and a straightforward DIY-friendly install. What we see on service calls is rarely the brand failing as a whole. It’s a handful of predictable wear points, and knowing which one you’re looking at saves you a replacement you don’t need.
- Dead batteries in solar and battery-backup units. The Ghost Controls TSS1 and similar solar-ready kits run on a 12V battery that quietly loses capacity over two to three summers of Summerlin heat. The gate starts stalling at the midpoint, then stops holding position. We load-test the battery under the actual gate load, not just at rest, and swap it if capacity is gone. A fresh battery and a re-check of the solar panel angle often brings a “dead” opener back to full function.
- Limit switches drifting out of set position. Ghost Controls arms use mechanical limits that drift after repeated thermal cycling. The symptom is the gate reversing a few inches short of full open, or hammering at the end of travel. We reset the limits to the gate’s true open and closed positions and photograph the new reading so the next tech starts from a known point.
- Control board water intrusion. The wall-mount control box on many Ghost Controls kits sits low on the wall and catches irrigation overspray and monsoon splash. Symptoms look electrical (no response to remote, random cycling) but the cause is corrosion on the board terminals. We dry, clean, and re-seal, then remount where it gets less splash. If the board is beyond recovery, we quote an OEM board.
- Arm bracket and pin wear. The actuator arm pins and the gate-side bracket take the full load of every cycle. Worn pins create slop, and slop makes the motor work harder and burn out sooner. We replace the pins and bracket shims rather than the whole arm whenever the actuator itself still tests clean.
- Photo-eye and safety-edge faults. Misaligned photo-eyes (the infrared beam that stops the gate if something crosses the path) are the single most common cause of a gate that opens partway and reverses. We realign the eyes, test them across the full travel, and confirm the safety edge stops the gate on contact before we call the repair done.
One detail you won’t find in the manual: Ghost Controls OEM arms and off-brand replacements are not fully interchangeable on gate geometry. An aftermarket arm may bolt up but change the travel arc, which then makes the limits impossible to set cleanly. We quote OEM arms where the geometry matters and quality aftermarket where it doesn’t, and we tell you which is which.
Styles & brands we work with
- Wrought iron
- Wood & steel frame
- Farm & ranch
- Sliding driveway gates
- LiftMaster operators
Our Ghost Controls Gate Motor & Opener Process

- 1
Phone triage. We ask what the gate is doing, the model on the arm, and how it’s powered (solar, battery backup, or AC). That shapes what parts we bring.
- 2
On-site diagnostics. We test battery capacity under load, check limit-switch readings, inspect the control board for corrosion, and test the photo-eyes and safety edge. Readings get written down.
- 3
Parts decision. If a part is needed, we tell you OEM versus quality aftermarket, the difference in price and warranty, and let you choose. No steering toward replacement when a repair gets you another several years.
- 4
Written price before work. The flat price is handed to you in writing before a single screw turns. No verbal quote, no surprise invoice at the end.
- 5
The repair and full-travel test. We cycle the gate through its full open and close, confirm all safety devices stop it correctly, and re-check the limits under load.
- 6
Documentation and cleanup. You get a photo log of every adjustment and the part numbers installed, in the job record. The site is left clean, and the 365-Day Done Right Promise covers the work.
Before
AfterWhat Ghost Controls Gate Motor & Opener Costs in Summerlin
Final price depends on the model, the gate width, and whether the control board is involved. Here’s the range we see across Summerlin jobs:
- Diagnostic and written estimate: free.
- Battery replacement (solar or backup unit): $150 – $300, parts included.
- Limit-switch reset and travel adjustment: $150 – $250.
- Photo-eye or safety-edge realignment or replacement: $150 – $350.
- Control board replacement: $300 – $600, depending on model.
- Actuator arm replacement (OEM or quality aftermarket): $400 – $900.
- Full opener replacement with new mounting: $900 – $1,800.
What moves the price most: gate weight and width, whether the arm brackets need replacing, and whether the wiring run has to be redone. Whatever the number, it’s written and agreed before any work starts. Call (844) 797-2809 for a free estimate.
See the difference
Before
After
Before
After
Before
AfterWhy Summerlin Homeowners Call Vance Gate Repair Summerlin for Ghost Controls Work

We’ve serviced gates across Summerlin long enough to know the local failure rhythm – solar batteries dying after a couple of triple-digit summers, control boxes catching irrigation splash, brackets loosening on walls that see real heat cycling. Our technicians have up to 12 years of experience and we work on nine major automation brands, so we’re not going to steer you toward a new opener just because your current one isn’t our favorite. Ghost Controls, LiftMaster, Mighty Mule, and DoorKing all get the same written price and the same photo record. The 365-Day Done Right Promise means a repair we performed is covered for a full year at no extra charge, and every visit is documented under the Haven Standard’s evidence clause. Call and a live person answers.
FAQs
It depends on what’s done and by whom. Ghost Controls’s warranty generally covers the unit itself against manufacturing defects, but the specifics vary by model and by whether parts are OEM. As an independent Ghost Controls service provider we’re not affiliated with the manufacturer, so we’re clear about which repairs keep you within the original warranty and which don’t. Call (844) 797-2809 for an exact quote – estimates are free.
We can source both. OEM Ghost Controls arms, control boards, and batteries are available, and quality aftermarket is an option where it makes sense on price without hurting the gate. We tell you the difference and let you decide. Call (844) 797-2809 for an exact quote – estimates are free.
Repair usually wins when the actuator, gate, and wiring are sound and the fault is in a battery, limit, board, or safety device. Replacement makes more sense when the arm is worn out and the geometry is off, or the board has failed twice. We give you both numbers so you can decide. Call (844) 797-2809 for an exact quote – estimates are free.
We answer the phone 24/7 and most Summerlin calls get same-day or next-day service. Call (844) 797-2809 and we’ll give you a real window, not a callback promise – someone answers every call.
Yes. Solar panel angle, charge-controller function, and battery capacity under real gate load are all part of our diagnostics on solar-ready Ghost Controls units. A surprising share of “dead opener” calls are a battery that just isn’t holding charge anymore. Call (844) 797-2809 for an exact quote – estimates are free.
Get Your Ghost Controls Opener Working Again

If your Ghost Controls gate motor or opener is stalling, reversing short of travel, or not responding at all, call Vance Gate Repair Summerlin at (844) 797-2809. We’ll diagnose it, hand you a written price before any work starts, and leave you a photo record of everything we found and fixed. Free estimate, live person on the phone, day or night.
Written by the team at Vance Gate Repair Summerlin, serving Summerlin and nearby areas.