Wrought iron
Wood & steel frame
Farm & ranch
Sliding driveway gates
LiftMaster operatorsFree on-site gate assessment - hinges, posts, and your LiftMaster or Nice gate operator checked before anything is quoted
The assessment is free and the quote is the invoice.
Get your free estimateDoorKing Keypad & Intercom Repair: The Summerlin Owner’s Guide
DoorKing keypad and intercom repairs in Summerlin typically run $240 to $520 installed, depending on whether we’re replacing a standalone keypad, a surface-mount intercom station, or a combined unit with a hands-free voice board. Most of these jobs are done same-day when the part is available locally, and you get a written price before we touch a screwdriver. We work on DoorKing units alongside eight other automation brands, so if your entry system has been swapped or mixed over the years, we can still identify what’s on the post.
Owners usually discover the failure the same way: the gate stops responding to the code they’ve used for years, or the intercom crackles when a delivery driver presses the call button and the house phone never rings. In Summerlin, the pattern we see most often is a keypad that works fine in the morning and acts dead by afternoon – that’s usually heat, not a dead board, and it’s worth diagnosing before anyone quotes you a replacement.
Key Takeaways
- Typical installed repair range: $240 – $520, quoted in writing before work starts.
- DoorKing uses several incompatible keypad protocols across model lines – the model number on the back plate matters.
- Summerlin’s summer heat cycles are hard on keypad faceplates and intercom speaker cones.
- We document every wire, terminal, and part number with photos before we leave.
- 365-Day Done Right Promise covers every repair we complete.
Which DoorKing Models This Applies To
DoorKing’s residential and light-commercial entry line splits into a few families you’ll run into on Summerlin driveways. The 1500 and 1510 series are standalone keypads and card readers. The 1800 and 1810 series are intercom and telephone entry systems – those are the units with a call button, a speaker, and usually a small directory display. The 1830 and 1835 series are the larger multi-tenant telephone entry stations, less common on a single-family driveway but still out there on shared HOA entrances around Summerlin.
Identifying your exact unit is straightforward: open the faceplate (usually two security screws at the bottom) and look for the model and serial label on the inside of the housing or on the back of the circuit board. Write the full model number down. DoorKing uses a suffix system – a 1500-080 isn’t the same keypad as a 1500-081, and the difference often comes down to voltage and protocol. A photo of the label on your phone is enough for us to match it.
On the OEM-versus-aftermarket question: for DoorKing specifically, we lean OEM on the circuit boards and keypad membranes because the aftermarket equivalents have a spotty record on weather sealing, and Summerlin’s sun and occasional monsoon moisture will find any weakness within a season. Housings, gaskets, screws, and speaker cones are fine in quality aftermarket – there’s no meaningful advantage to paying OEM prices for a rubber gasket.
Styles & brands we work with
- Wrought iron
- Wood & steel frame
- Farm & ranch
- Sliding driveway gates
- LiftMaster operators
Signs Your DoorKing Keypad & Intercom Repair Is Failing

Here’s what we actually find when we open these units in Summerlin:
- Code works intermittently, then stops. The keypad membrane or the tactile switches beneath it are wearing through. On a DoorKing 1500 series, this usually shows up first on the 1, 4, and 7 keys because those get pressed most.
- Intercom crackles or drops to silence mid-call. The speaker cone has degraded or moisture has gotten into the voice board. We see this most on units facing west, where afternoon sun does the most damage.
- The call button lights up but nothing rings inside. Either the phone line connection at the terminal block has corroded, or the voice board’s ring detection circuit has failed. DoorKing’s 1800 series is prone to this after eight to ten years in service.
- Keypad beeps but the gate doesn’t move. The keypad is fine – the relay output or the low-voltage wiring back to the operator is the problem. This is the single most common misdiagnosis we correct: homeowners get quoted a full keypad replacement when the issue is a corroded splice twelve feet away.
- Display is blank, garbled, or stuck on a scrolling message. Power supply voltage sag or a failing display driver. On a 1830 series this can also indicate the controller board is on its way out.
See the difference
Before
After
Before
After
Before
After
Before
AfterReplacement Cost & What’s Included
Installed pricing in Summerlin runs $240 – $520 for most DoorKing keypad and intercom repairs. The range breaks down like this:
- Keypad membrane or switch replacement: $240 – $320
- Standalone keypad replacement (1500/1510 series): $320 – $420
- Intercom speaker or voice board repair: $280 – $400
- Full intercom station replacement (1800/1810 series): $420 – $520
- Wiring repair or terminal block replacement: $180 – $260 (often bundled with the above)
The price you’re quoted covers the part, the labor, and the documentation. Under Haven Standard Clause 1, that price is written and handed to you before any work starts – no surprise line items at the end. Every repair carries the 365-Day Done Right Promise: if it fails within a year, we make it right at no charge. We don’t claim to stock parts or carry them on a truck; parts are sourced to match your model, and if a local supplier has it, most Summerlin jobs are completed same-day. If not, we tell you the lead time upfront.
DIY or Call Us?

Some things you can safely check yourself. Power-cycling the unit at the breaker is fine. Inspecting the wiring terminals for obvious corrosion or loose screws is fine. Reading the model number off the label and photographing it, definitely fine.
Where DIY goes wrong on DoorKing units is at the circuit board and the low-voltage wiring. These systems run on low voltage, but the controller board is sensitive, and a mis-wired terminal can fry a board that costs more than the original repair. There’s also a phone-line connection on the intercom units – touching that while the line is live can give you a shock and can damage the phone company’s equipment. And if the keypad has failed because of a deeper wiring issue, replacing the keypad alone gets you a new keypad that fails the same way.
We’re not affiliated with DoorKing; we’re an independent service provider. That means we’re diagnosing your actual problem, not steering you toward a specific replacement part. If you want a second opinion on a quote you’ve already received, bring it to us – we’ll review it at no cost.
Call (844) 797-2809 for a written price before any work starts. A live person answers 24/7.
FAQs
Eight to twelve years is typical for a DoorKing keypad or intercom in Summerlin, though we regularly see units fail at six years when they’re in direct afternoon sun. The circuit board outlasts the keypad membrane and the speaker cone almost every time – which is why we look at the wear parts first. Call (844) 797-2809 for an exact quote – estimates are free.
Often, yes. Keypad membranes, tactile switches, speaker cones, and terminal blocks are all replaceable on most DoorKing models, and that’s usually a $240 – $320 job rather than a full unit swap. We diagnose first and only recommend replacement when the board itself has failed. Call (844) 797-2809 to schedule a diagnostic – the written price comes before any work.
Most keypad and intercom replacements take one to three hours on site, depending on whether the wiring needs re-terminating and whether the existing housing is reusable. We tell you the expected window when we quote. If a part has to be ordered, we give you the lead time upfront rather than guessing. Call (844) 797-2809 with your model number and we’ll tell you what’s realistic.
We match the exact model and suffix number from your unit’s label to the correct DoorKing part, then source it from suppliers who stock OEM and quality aftermarket equivalents. You get the part number in writing on the invoice and in the photo record we leave behind. If you’ve been quoted a part that doesn’t match your model, bring us the paperwork – we’ll review it at no cost. Call (844) 797-2809.
Written by the team at Vance Gate Repair Summerlin, serving Summerlin and nearby areas.