Wrought iron
Wood & steel frame
Farm & ranch
Sliding driveway gates
LiftMaster operatorsFree on-site gate assessment - hinges, posts, and your LiftMaster or Nice gate operator checked before anything is quoted
The assessment is free and the quote is the invoice.
Get your free estimateMighty Mule Keypad & Intercom Repair: The Summerlin Owner’s Guide
Mighty Mule keypad and intercom repair in Summerlin typically runs $185 to $420 installed, depending on whether we’re swapping a keypad, an intercom station, or both units on the same post. We work on the Mighty Mule entry keypads and intercom entry stations that sit at the driveway column or pedestrian gate, and because we’re independent we source what the gate actually needs rather than steering you toward a full replacement. Most Summerlin homeowners find us after the keypad stops taking their code in the afternoon sun, or the intercom goes silent on one side while the gate itself still cycles fine.
Which Mighty Mule Models This Applies To
Mighty Mule entry keypads (the wired and wireless versions sold alongside the M380, M880, MM560, and similar swing-gate operators) and the Mighty Mule intercom entry stations show up on a lot of Summerlin driveway columns and pedestrian gates. The key gotcha: Mighty Mule has shipped more than one keypad generation, and the wireless units are not backward-compatible with older receivers. If your post has a first-generation receiver, a new keypad won’t pair no matter how many times you press the learn button – the receiver has to match the keypad’s frequency. That’s the single most common wrong-part purchase we see here.
To identify yours, look for the model label on the back of the keypad housing or inside the intercom faceplate, and note the wire count coming out of the post – two-wire keypads and four-wire intercom stations are not interchangeable. Bring us a photo of the label and the wiring and we’ll match it before anything is ordered. On OEM versus aftermarket: Mighty Mule’s own keypads are the safe match if you want a drop-in, while quality aftermarket equivalents can save money on the intercom side but need the right voltage and terminal layout verified first. We don’t claim to stock parts or carry them on a truck – what we do is confirm the exact part, order it if needed, and install it correctly.
Styles & brands we work with
- Wrought iron
- Wood & steel frame
- Farm & ranch
- Sliding driveway gates
- LiftMaster operators
Signs Your Mighty Mule Keypad & Intercom Repair Is Failing

Here’s what actually fails on these units in the Nevada heat and dust, and the cause behind each symptom.
- Keypad accepts the code but the gate won’t open. The keypad is fine; the signal isn’t reaching the operator, usually a corroded splice at the post or a receiver that’s drifted out of range. We continuity-test the run and photograph the splice point.
- Keys go dead or only work after a hard press. Sun-baked membrane keypads lose their contact pads after a few summers. The fix is a keypad swap, not a repair – the membrane isn’t serviceable.
- One side of the intercom is silent. Usually a failed speaker in the entry station or a broken wire in the buried run, and the two look identical from the driveway. A meter tells them apart in minutes.
- Intermittent beeps or phantom entries. Dust and moisture in the keypad housing create stray contact. It reads like a security problem but it’s a worn keypad gasket letting grit in.
- Backlight flickers or dies. The low-voltage feed to the post has dropped below what the unit needs, often a failing transformer or a corroded connection at the gate operator’s accessory terminals.
See the difference
Before
After
Before
After
Before
After
Before
AfterReplacement Cost & What’s Included
Most Mighty Mule keypad replacements in Summerlin land between $185 and $295 installed, and intercom entry station swaps run $240 to $420 depending on wire condition and whether the run needs re-terminating. Doing both on the same post usually comes in at the lower end of the combined range since we’re already there and the labor overlaps.
What drives the number: the exact part, whether the receiver needs replacing to match a newer keypad, and whether the buried low-voltage run is intact. The flat price is written and handed over before any work starts – that’s Haven Standard Clause 1, and it means no surprise invoice at the end. Every install is covered by our 365-Day Done Right Promise: if the keypad or intercom isn’t right, we make it right within a full year at no additional charge. Before we leave, you get a photo log of the wiring, the part number installed, and the terminal readings.
DIY or Call Us?

You can safely check a few things yourself: confirm the keypad has power with a non-contact voltage tester, look for visible corrosion or loose screws at the post, and note your model label. That’s it. The work that actually fixes these units – tracing an intermittent low-voltage fault, verifying the receiver matches the keypad frequency, re-terminating the intercom run – is where DIY goes wrong and where a homeowner ends up buying the same part twice.
These systems run on low voltage, so the shock risk is small, but a mis-wired keypad can back-feed the gate operator’s accessory circuit and take the whole operator down. We’d rather you not gamble the operator to save a keypad. Call (844) 797-2809 and we’ll walk you through what you’re seeing – a live person answers 24/7, no voicemail loop.
FAQs
How long does a Mighty Mule keypad or intercom last in Summerlin? Expect seven to ten years out of a keypad and a bit longer from a hardwired intercom station, but the desert sun shortens that. Units on an unshaded west-facing post here often fail closer to five or six years because the membrane and gasket bake. Call (844) 797-2809 for an exact quote – estimates are free.
Can my failed keypad or intercom be repaired instead of replaced? Sometimes. A dead intercom speaker or a corroded splice can often be repaired, and a keypad that’s only lost its receiver match just needs the correct receiver, not a new keypad. We test before we recommend, so you’re not paying for a part you didn’t need.
How long does the swap take? A straight keypad or intercom swap is usually a same-day visit and takes 45 minutes to an hour and a half, assuming the wiring is sound. If we’re tracing a buried-run fault or ordering a matched receiver, we schedule it once the part is confirmed. Call (844) 797-2809 and we’ll give you the timing up front.
How do you source the part? We confirm your exact model from the label and wiring, order the matched keypad or intercom station, and verify it against your operator before we install. We don’t claim to keep parts on a truck – but we do make sure the part fits before anyone drives out. Call (844) 797-2809 to get started.
Vance Gate Repair Summerlin is an independent service provider and is not affiliated with Mighty Mule. We also service keypads and entry hardware on LiftMaster, Ghost Controls, and DoorKing systems, so whatever motor is already on your Summerlin property, we can work on it rather than push a replacement. Call (844) 797-2809 for a free estimate and a written price before any work begins.
Written by the team at Vance Gate Repair Summerlin, serving Summerlin and nearby areas.