Wrought iron
Wood & steel frame
Farm & ranch
Sliding driveway gates
LiftMaster operatorsFree on-site gate assessment - hinges, posts, and your LiftMaster or Nice gate operator checked before anything is quoted
The assessment is free and the quote is the invoice.
Get your free estimateMighty Mule Gate Repair in Summerlin: What to Know First
We repair Mighty Mule gate operators and the gates they move across Summerlin, and most swing-gate jobs are finished in a single visit once the right parts are on hand. Arm and control-board failures that are easy to diagnose often close same-day; anything needing a factory-ordered board or a replacement arm is scheduled and priced in writing first. You get a flat price before we start, and a 365-Day Done Right Promise on the work.
This page is for the Summerlin homeowner who already owns a Mighty Mule – maybe an MM260, an MM560, or a solar MM371W – and wants the gate working again, not a sales pitch toward a new system. Call (844) 797-2809 and a live person answers, any hour.
How Mighty Mule Products Fail – and How We Fix Them
Mighty Mule is a popular DIY-friendly line, and that shows up in how the units fail. Here are the patterns we see most in Summerlin, with the fix for each.
- MM260 / MM360 arm that binds mid-travel. The single-arm operator on these kits leans on a plastic-driven gearbox, and after a few desert summers the grease in that gearbox thickens and the arm surges then stalls. We open it, clear the old grease, and check the drive gear for tooth wear. Often a clean and re-grease plus a limit re-set gets it back to smooth travel; if the gear is chewed, we quote a replacement arm and tell you the OEM-versus-aftermarket difference before you decide.
- Control-board water damage on the MM560. The control box seal lets in fine grit and, in Summerlin’s occasional monsoon weeks, water that pools near the terminal block. The symptom is a gate that starts then stops, or a remote that works only up close. We photograph the corrosion, dry and treat the terminals, and replace the board if traces are gone.
- Solar units that “die” in the July heat. An MM371W or similar solar setup that stalls at midday usually is not the motor – it’s the battery dropping below operating voltage when the panel is heat-soaked. We load-test the battery, check the panel angle and charge lead, and tell you whether a fresh battery restores it or the panel needs repositioning.
- Limit switches knocked off set-point. On most Mighty Mule operators, a gate that slams or reverses early traces to a limit switch set 10-15 degrees past travel. We re-set the cam, test full open and full close, and photograph the new stop position so it’s documented.
- Hinge, post, and arm-bracket wear. A weak gate hinge or a post that has settled puts side-load on the arm and burns the motor trying to compensate. We re-weld or re-hang the gate, true the post, and realign the arm bracket so the operator isn’t fighting the gate.
As an independent Mighty Mule service provider, we work on the unit already on your property and never steer you toward replacement when a repair is the right call.
Styles & brands we work with
- Wrought iron
- Wood & steel frame
- Farm & ranch
- Sliding driveway gates
- LiftMaster operators
Our Mighty Mule Gate Repair Process

- 1
Call and describe the symptom. A live person answers 24/7 – no voicemail loop. We ask brand, model, and what the gate does (stalls, reverses, won’t move), so the tech arrives with the right parts mindset.
- 2
On-site diagnosis with documentation. We test the arm, limit settings, photo-eye alignment, and board voltage, and photograph what we find – the same wiring-diagram habit our techs carry over from commercial access-control work.
- 3
Parts decision in writing. OEM versus quality aftermarket is laid out side by side with the trade-off named – OEM for exact fit and warranty-safe repair, aftermarket for cost – and you choose before anything is ordered.
- 4
The repair. We make the fix with the part you approved, whether that’s a re-greased gearbox, a re-set limit, a new arm, or a board swap.
- 5
Full travel test. Open, close, reverse-on-obstruction, and remote range all get checked, and readings are recorded.
- 6
Photo record and 365-Day Done Right Promise. Before we leave, you get a photo log of every adjustment and a written record of the part number installed, backed by one full year to make any repair right at no extra charge.
Before
AfterWhat Mighty Mule Gate Repair Costs in Summerlin
Every price is quoted and agreed before work starts – no “call for a quote,” no surprise invoice at the end.
| Mighty Mule Job | Typical Range |
|---|---|
| Diagnostic + limit re-set / photo-eye realign | $120 – $220 |
| Control-board replacement (MM560-class) | $260 – $420 |
| Swing-arm replacement (OEM or aftermarket) | $380 – $650 |
| Hinge / post / arm-bracket repair or weld | $150 – $400 |
| Solar battery + charge-lead service | $140 – $280 |
What moves the price: whether parts are factory-ordered (adds a day or two), arm-bracket condition, and whether the gate itself needs truing first. Estimates are free.
See the difference
Before
After
Before
After
Before
AfterWhy Summerlin Homeowners Call Vance Gate Repair Summerlin for Mighty Mule Work

We’ve repaired and installed more than 22,000 gates since 2014, and every job gets a written price first and a documented photo record when we leave. Our technicians have up to 12 years of experience and are background-checked, so you know who is coming before they arrive.
Mighty Mule is one of nine brands we service. If a Summerlin homeowner has a LiftMaster, Ghost Controls, or DoorKing operator, we work on that too – one company for whatever motor is on the property. That means we can be honest about repair versus replace instead of pushing one brand.
Bring a written estimate from another company and we’ll review it free as a second opinion. Under the 365-Day Done Right Promise, if the repair isn’t right, we make it right – no argument, no fee.
FAQs
Is my Mighty Mule repair covered by a warranty?
Yes. Every repair we complete is covered by our 365-Day Done Right Promise, giving you a full year for us to make any repair right at no additional charge.
Can you get Mighty Mule parts in Summerlin?
We source both OEM and quality aftermarket Mighty Mule parts, and we lay out the trade-off in writing so you can choose. Factory-order parts add a day or two to turnaround. Call (844) 797-2809 for exact availability.
Should I repair or replace my Mighty Mule operator?
Most Mighty Mule failures we see – limits, boards, batteries, arm brackets – are repairable and don’t need a new system. We diagnose first and only recommend replacement when the board and motor are both beyond saving.
How fast can you come out?
Many Mighty Mule arm and limit jobs close same-day, and we respond fast across Summerlin; anything needing a factory-ordered part is scheduled and priced up front. Call (844) 797-2809 and a live person will give you a window.
Do you work on solar Mighty Mule units?
Yes. Solar units like the MM371W are common in Summerlin’s sunny lots, and most “dead motor” calls trace to a battery or panel-angle issue we can test and fix on site.
Get Your Mighty Mule Gate Working Again

If your Mighty Mule gate is stalling, slamming, or sitting dead, call (844) 797-2809 for a free estimate. A live person answers at any hour, and you’ll have the price in writing before any work begins.
Written by the team at Vance Gate Repair Summerlin, serving Summerlin and nearby areas.